LED transparent displays are increasingly used in various industries and are favored by major merchants. Various problems inevitably accompany daily use. The editor will analyze the precautions for using LED transparent display for everyone, let's take a look!

LED transparent display usage environment

1. The working environment temperature range is -20℃≤t≤50℃, and the working environment humidity range is 10% to 90%RH;

2. During the use of the display screen, avoid using or storing it in high temperature, high humidity, high acid/alkali/salt environments;

3. Keep away from flammable items, gases and dust;

4. When the ambient temperature is too high or the heat dissipation conditions are not good, please be careful not to use the LED transparent display for a long time; it may easily cause the circuit board inside the display to burn out.

5. When an LED transparent display with a humidity exceeding the specified humidity is powered on, it will cause corrosion of components or even short circuit, resulting in permanent damage;

6. It is strictly prohibited to allow water, iron powder and other easily conductive metal objects to enter the screen. LED transparent displays should be placed in a low-dust environment as much as possible. Excessive dust will affect the display effect and easily damage the circuit. If water enters due to various reasons, please turn off the power immediately and dry all components before use.

Switching sequence of LED transparent display

1. Pay attention to the switch sequence when turning on the screen: turn on the phone first, then turn on the screen after the screen is fully lit and preheated. When turning off the screen, the sequence is reversed: turn off the screen first, then turn off the phone. If you turn off the computer first, the screen will be highlighted and the lamp will burn out easily, affecting the service life of the screen and causing serious consequences.

2. The time for turning on and off each time should be more than 5 minutes. If the machine is turned on and off frequently, it will cause a short service life of the display and short circuit of the display.

3. Only after the computer enters the engineering control software can the screen power be turned on.

4. Avoid turning on the screen when the screen is all white, because the inrush current of the system is the largest at this time.

5. When the ambient temperature is too high or the heat dissipation conditions are not good, LED lighting should be careful not to turn on the screen for a long time.

6. If there is a very bright line on a certain part of the electronic display screen, the screen should be turned off in time. In this state, it is recommended not to turn on the screen for a long time.

7. The power switch of the display screen often trips. At this time, you should check the screen or replace the power switch in time.

8. Regularly check the firmness of the hook. If there is any looseness, please make timely adjustments and re-reinforce or update the suspension components.

9. According to the environmental conditions of the display screen and control components, insect bites should be avoided and anti-rodent pesticides should be placed if necessary.